Zhenghong Trade Ltd
ciscosell.com
Add to Cart
RS232 cable Cisco Network Modules SCE8000-SCM-E with RJ11 port Bypass
Table 2-2 SCE8000-SCM-E Ports
|
Description |
Connect This Port to... |
|
Gigabit Ethernet RJ-45 ports for management of the Cisco SCE8000. CLI designation: interface GigabitEthernet 1/1, 1/2. |
A LAN using a GBE cable with an RJ-45 connector. |
|
RS-232 RJ-45 port for use by technicians |
A local terminal (console) using an RS-232 cable with an RJ-45 connector, as provided in the Cisco SCE8000 kit. |
|
RS-232 RJ-45 port used by technicians |
— |
|
RJ-11 port |
The control connector on the optical bypass module. |
Table 2-3 SCE8000-SCM-E LED Description
|
LED |
Description |
|
Power |
•Steady green—Installed power supplies are functioning normally. •Steady amber—Only one power supply is functioning normally. •Unlit—No power from either power supply. On a slave SCE8000-SMC_E module (in the second slot), this LED is always off. |
|
Status |
The Status LED indicates the operational status of the Cisco SCE8000 system, as follows: •Unlit—No power from either power unit. •Steady amber—System is booting up. •Flashing amber—System is operational, but is in a warning state. •Flashing green—System is fully operational. •Steady red—Problem or failure. Alarms are hierarchical: Failure takes precedence over Warning, which takes precedence over Operational. |
|
Optical Bypass |
•Steady amber—The optic bypass module is directed to pass traffic through the Cisco SCE8000. •Unlit—The optic bypass module (if present) connects link fibers directly, and traffic bypasses the Cisco SCE8000. On a slave SCE8000-SMC_E module (in slot 2), this LED is always off. This functionality is consistent even when the Cisco SCE8000 is powered off. |
|
Master |
Indicates the master service control module •Steady green—Master service control module •Unlit—Slave service control module |
|
Mng interface |
The Mng interface LEDs indicate the operational status of the Cisco SCE8000 out-of-band LAN-based management port, as follows: •Link/Active Steady green—Port link is up Flashing green—Activity on the port link Unlit—Port link is down •Speed Unlit—Port is set to 10 Mbps Steady green—Port is set to 100 Mbps Steady amber—Port is set to 1000 Mbps On a slave SCE8000-SMC_E module (in the second slot), this LED is always off. |